Trianglelab PT1000 Thermistor for 3D Printer Hotends, up to 450°C, Pro M3/M4, Cartridge or Bare

We need to discuss the freight with you. The trianglelab has always been concerned about product quality. We are developing products and working hard to improve the quality. We will not abandon our reputation because of many cheap products on the market. It is believed that only high quality products can ensure the quality of your work and bring safety to your work. Some of our products may be more expensive than others, but please believe in our quality and believe that you will not regret when you receive the goods. PT1000 Pro Thermistor M3/M4 *All information can refer to PT1000 information：Trianglelab Thermistor Cartridge PT1000 Upto 450 degrees. ▉Name: PT1000 /PT1000 Pro/Pro Thermistor M3/M4 ▉Marlin Firmware Configuration: Connect directly to the thermal interface of the control board and then determine which one to choose according to the pull-up resistor of the interface. In most cases it is 4.7K ohms, please check your motherboard manual for details. • 1010 : Pt1000 with 1kΩ pullup • 1022 : Pt1000 with 2.2kΩ pullup • 1047 : Pt1000 with 4.7kΩ pullup ▉Klipper documentation: Directly connected PT1000 sensor. The following parameters are available in heater sections that use one of these sensors. sensor_type: PT1000 sensor_pin: # Analog input pin connected to the sensor. This parameter must be # provided. #pullup_resistor: 4700 # The resistance (in ohms) of the pullup attached to the sensor. The # default is 4700 ohms. ▉Description: PT1000 sensors are able to measure higher temperatures than thermistors - upto 400°C,and are more accurate then both thermistors and thermocouples in general. PT1000 sensors can direct replace the thermistors in your printer without adding an amplifier board like PT100's sensors. but whith the default 4.7K pullup resister on board you will get lower resolution than other sensors. PT1000 sensors are compatible with most firmwares in the field. PT1000 sensors are potentially a good cost and performance compromise between thermistors and PT100 sensors. If you want release potential abilities of the PT1000 sensors,you need to replace the 4.7Kpullup resister of the thermistor pins with a 1K 0.1% resister. continuous 500 degree Celsius Guaranteed